Description
Operation:
1. Connect to the power and turn on the switch. 220v-50Hz, Please use the single-phase three socket, the outlet should be reliable ground protection.
2. Push on the power switch“10″, power indicator “11” shine means power on.
3. Pressing heating switch“12”, waiting 10 min to heating. No need to turn off the heating switch, which is the automatic temperature controller.
4. First put a small number of raw materials for pressing, to test whether the machine can be normal operation. Put the material in the hopper“2″, fine-tuning the Trim handwheel“3″, Clockwise turning handwheel to not move, rotating around 360°.
5. Press start press button“15″, if any abnormal press“14”. If any foreign body enters the pressing chamber, stop the machine and press the Reversion button“13”，when the foreign body is out of the machine then continue pressing.
6. Press the button “12” when materials pressing finished. And let the machine working empty for 3- 5 minutes. turn off“12″ and“14”.
Attention:
1. Operators must understand the technique and performance of oil press that can operate independently
2 . Prohibited metal or other hard objects into the pressing chamber. Do not use the metal bar in the Feed inlet.
3. When pressing switch shaft jammed, not troubleshooting, prohibit forced to start, to avoid damage to parts and other accidents.
4. The oil cake should cool below 40 deg. so that can be stacked and packaged to prevent spontaneous combustion.
5. Prohibit the use of high-power motors to drive the oil press.
6 . While the machine is working, the operator shall not leave.
Disassemble:
1. Press the reverse button to make the machine swivel back for 30 seconds so that the pressing frame and rod can be easily separated.
2. Do remember to put on a glove to disassemble the pressing frame when the extraction is just finished. Or let the machine cool down for a while and then disassemble.
3. Take out the pressing screw and chamber.
Common Problem & Solution:
I. If any foreign body enters the pressing chamber.
Stop the machine and press the Reversion button, when the foreign body is out of the machine then cleaning the chamber and screw, continue pressing.
2. Screw cannot take out from the chamber.
Put it in the machine and let the machine idle away for 5 minutes.
3. Power off above 30 minutes.
Stop add material, turn off the power, and plug. Clear the hopper When power on, continue pressing after heating for about 20 minutes. if the oil press machine still can not working normally, the pls get out of the chamber and screw. after clear them Start to press gain.
